GAP red LED chip some light color is orange, this is because of its luminous mechanism is a direct leap. Affected by impurity concentration, current density increases, easy to occur impurity level migration and full luminescence, luminescence is the beginning into orange. LED lighting entered the field of incandescent lighting in 2007, and entered the fluorescent lighting market in 2012, and replaced incandescent and fluorescent lamps in 2020.
CL3641AB 0.36 inch
CL3641AB LED
CL3641AB Blue
CL3641BB 7-segment
CL3641BB Display
CL3641BB 4-digit
The most obvious is in the 5050 lamp belt, 5050 lamp belt in which any chip circuit has a short circuit, it will cause a short circuit of the lamp bead current rises twice, that is, 20mA into 40mA, the brightness of the lamp bead will become very bright, but at the same time the heat will also increase sharply, serious will burn the circuit board within a few minutes.
3101AW LED
3101AW 7-Segment
3101BW Display
3101BW 0.30 inch
Yole data shows that the global miniLED display equipment is expected to grow from 324 million units in 2019 to 800.7 million units in 2023, with an annual compound growth rate of up to 90%. According to TrendForce LED research, it is estimated that the output value of mini LED backlight will reach $340 million in 2023 (only the output value of mini LED backlight, excluding other driver IC and backplane). The global layout is relatively balanced, and the industrial chain is not fully integrated. At the present stage, the layout of Mini LED technology is more balanced, and the competition pattern is not clear.
CL3942AH LED
CL3942AH 0.39 inch
CL3942BH 7-Segment
CL3942BH Display
The aluminum base welded with the heat pipe and the profiled heat fin are welded together to form a heat fin assembly. The heat fin assembly is installed from the rear of the lamp housing and fixed by screws. Heat dissipation analysis results, LED high beam lamp heat dissipation analysis results, high-power LED auto lamps use heat pipe and heat sink combined heat dissipation method, through the electronic heat dissipation software ICEPAK simulation of high-power LED lamps heat dissipation effect, at the ambient temperature of 50℃ simulation results, as shown in the figure, the highest temperature on the lamp board is 64℃.
Red
3521AB LED
3521AB 5-digit
3521BB Segment
3521BB 
